If you are planning on using taps which fix onto the vanity unit then simply tell us where you would like them.

It will fit into very tight spaces due to its low level design, ideal where space is often very limited and difficult to access. The Uniwaste™ will fit a waste of 1 ¼ inch and 1 ½ inch and 1 ¼ inch push fit or Polypipe at the bottom end. Uniwastes can be adapted at the bottom end for 1 ½ inch pipe with a McAlpine T29 or equivalent compression or solvent adapters.

For guarantee periods on our taps, please check the individual product pages for further information.

It will fit into very tight spaces due to its low level design, ideal where space is often very limited and difficult to access. The Uniwaste™ will fit a waste of 1 ¼ inch and 1 ½ inch and 1 ¼ inch push fit or Polypipe at the bottom end. Uniwastes can be adapted at the bottom end for 1 ½ inch pipe with a McAlpine T29 or equivalent compression or solvent adapters.

PLEASE NOTE: Standard placement of Knobs are as follows: Horizontally & vertically centred on drawer fronts, and vertically centred and 40mm in from the edge of doors.

PLEASE NOTE: Standard placement of Cup Handles are as follows: Horizontally & vertically centred on drawer fronts, and vertically centred and 40mm in from the top edge of doors or the inside of a shaker panel.

PLEASE NOTE: Standard placement of Cup Handles are as follows: Horizontally & vertically centred on drawer fronts, and vertically centred and 40mm in from the top edge of doors or the inside of a shaker panel. Standard placement of Knobs are as follows: Horizontally & vertically centred on drawer fronts, and vertically centred and 40mm in from the edge of doors.